The stabilizer is designed to handle 275 bbl/d (43.7 m3/d) of condensate at steady state when the plant is operating at 120 MMscfd (3400 E3m3/d). This includes a 10% contingency. The package has a minimum inlet flow of 137 bbl/d (21.9 m3 /d) of condensate. If thecondensate rate drops below this level the package will be operated in a batch mode until the minimum flow is reached again. The stabilizer tower can only be turned down to 2:1 and meet the guaranteed product spec from the vendor.

Note: The connective piping for the cooler is missing.

A clean, well appointed 48” Separator Package. Built by Presson in 2000, this unit was designed to pump condensate right off the bottom the vessel via dual Wheatley T255M triplex pumps w/ 1.25” plungers. Vessel is a 2 Phase design shut down & blocked in in 2013; opened, cleaned and installed a nitrogen blanket in July 2015. In addition, everything is fully wired to junction boxes c/w lights, fire loop, beacons, ESD, 120V start Catadynes, exhaust fans etc. Located by Rocky Mountain House.

Skid & building are 11’ W x 36’ L

Shipping dimensions are with prover lines removed as well as door & outside light hoods 13’ 5” W x 38’ 6” L x 17’ H including ridge vent. (16’6” + 6”)

Drawings do not exist.

=======================
ADDITIONAL INFORMATION
=======================

View full listing details and 360º virtual walkthrough of this equipment at https://www.crusaderjv.com/equipment/sour-48-x-16-presson-1440psi-separator-ces1833/

• (2) firetubes each Flameco burner is 1.8 MM/Btu. Total heat duty is 3.60 MM/btu per hr.

• Please see the end plate. It has spray nozzles on the firetubes.

Both turbine units are in excellent condition with very low hours for their age. Each unit has had the generator end refurbished (documentation included). General refurbishment activities on the remaining items has been completed.

Units have 15,166 & 20,222 hours of use. 292 & 472 starts.

5.2MW at sea level, 59°F, no inlet or exhaust losses, 11,882 BTU/kwh on Natural Gas. Inlet and exhaust ducting, Self Cleaning inlet air filter, Electric motor starting, Outdoor enclosures, control cab with switchgear, MCC, etc.

Commissioned in 11/6/01, and maintained by Solar. Taken out of service, stored inside building 2006-2009 disassembled and moved in 2009 to present site and inspected by Solar. Generator Ends rebuilt. May 30, 2019 Borescope reports available.

Description:

The package comprises the following major components along with all GE scope of supply and auxiliaries:

• Frame 7EA Gas Turbine model PG7001EA (7E.03)
• Dry Low NOx (for DLN 1.0 Combustion System*)
• Natural gas single fuel supply
• Design Site Output/Heat Rate 84.6MW at 1916 ft and 32°F; 91MW at 0 ft and 32°F
• Includes GE PIP package (minus Stg 3 Aero), 2055°F firing temp
• Inlet/Exhaust: Pressure drop: 3.5/5.5 inches of H2O
• Hours: factory test fire only, i.e. New
• Control System: MKVIe Speedtronic TMR
• Generator: GE/Andritz
• Frame: BDAX (Brushless)
• Excitation: GE EX2100
• Frequency/Power Factor: 60 Hz/0.85 pf
• Rated Output: 101.8 MVA
• Cooling: Air-cooled
• Designed for the Canadian Market
• Stored in accordance with GE's storage/preservation requirements
• Unit has not been rotated  - Not required on 3 bearing units
• Borescope on GTG and quarterly electrical insulation resistance check on the generator

Other Auxiliary Equipment Available Upon Request
(not included in asking price - please call us to inquire):

• Air Cooled Glycol Heat Exchangers c/w VFD’s, Filters, Glycol Pumps, GSU Transformer,
• Glycol Expansion Vessel, 52G synchronizing breaker compartment included @ 13.8KV incl. all protection relays etc. - Terminal Voltage: 13.8Kv (2 pole, 3-phase, Wye conn.)
• Heat Recovery Steam Generator (HRSG – Not Complete)

*Combustion system (for GTG) not included or installed – Combustor Components from refurbished parts are available upon request at additional cost.

Below is the list of missing combustion components:

• Primary Fuel Nozzles
• Secondary Fuel Nozzles
• Flow Sleeves
• Liners
• Cross Fire Tubes
• Transition Pieces and TP Seals
• All gaskets, nuts, bolts, screws, pins to install the above

Burner systems are not included

Package shut in 2013

Blowcase = approx 25500 cycles (Dec 2010 to April 2013)

1,478HP Reciprocating Compressor Package

Package was preserved on Oct 29 / 2018 and has 26,000 run hours since last overhaul.

GB - MOTHBALLED 09-01-16